| |
| 文章导读 |
|
摘要小尺度实验是测量服装热阻常用的方法之一。为了测量高温下服装热阻,该文在锥形量热仪的基础上,设计了一套用于研究多层织物热传递机理的小尺度实验测试装置,建立了高温热辐射下使用热平板测量热阻的计算公式。基于该实验装置,在1~10 kW/m2的低热辐射强度下测量了多层防护服织物的内部温度变化以及穿透防护服之后的热流密度。结果表明: 随着热辐射强度的增加,尤其是在热辐射密度超过5 kW/m2时,总热阻减小,外层、防水层和隔热层的热阻减少,而舒适层的热阻先增大后减小; 低辐射强度下(不超过10 kW/m2), 织物对热辐射吸收率的变化对高温低辐射条件下热阻的测量影响可以忽略不计。
|
| 关键词 ：热防护性能,热阻,防护服,高温,热辐射 |
Abstract：Bench scale tests are often used to measure the thermal insulation of protective clothing. The thermal insulation is one of the main parameters controlling the clothing thermal comfort and protective performance. A bench-scale system is developed to measure the heat transfer within a multi-layer fabric using a cone calorimeter. A model is then developed to calculate the thermal insulation in hot environments. This paper presents measurements of the thermal insulation of the multi-layer fabric for low intensity thermal radiation of 1-10 kW/m2. The tests show that the total thermal insulation decreases with increasing heat flux as the local resistances of the outer shell layer, the moisture layer and the thermal barrier layer decrease, while that of the inner layer increases at first and then decreases. The influence of the thermal radiation reflectivity can be neglected for low intensity thermal radiation less than 10 kW/m2.
|
| Key words：thermal protective performancethermal insulationprotective clothinghot environmentthermal radiation |
| 收稿日期: 2013-06-13 出版日期: 2015-03-17 |
| 基金资助:国家自然科学基金资助项目(51076073, 91024024);国家“九七三”重大基础研究项目(2012CB719705) |
| [1] | Havenith G, Holmer I, Parsons K. Personal factors in thermal comfort assessment: Clothing properties and metabolic heat production[J]. Energy and Buildings, 2002, 34(6): 581-591. |
| [2] | Holmer I. Protective clothing in hot environments[J]. Industrial Health, 2006, 44(3): 404-413. |
| [3] | Broede P, Kuklane K, Candas V, et al.Heat gain from thermal radiation through protective clothing with different insulation, reflectivity and vapour permeability[J].International Journal of Occupational Safety and Ergonomics, 2010, 16(2): 231-244. |
| [4] | McCullough E A. The use of thermal manikins to evaluate clothing and environmental factors[J]. Elsevier Ergonomics Book Series, 2005, 3(1): 403-407. |
| [5] | Huang J H. Sweating guarded hot plate test method[J]. Journal of Thermal Biology, 2010, 35(4): 197-203. |
| [6] | Gibson P, Auerbach M, Giblo J, et al.Interlaboratory evaluation of a new sweating guarded hot plate test method (ISO 11092)[J]. Journal of Building Physics, 1994, 18(2): 182-200. |
| [7] | Song G, Paskaluk S, Sati R, et al.Thermal protective performance of protective clothing used for low radiant heat protection[J]. Textile Research Journal, 2011, 81(3): 311-323. |
| [8] | Broede P, Kuklane K, Havenith G, et al.Heat gain from thermal radiation through protective clothing with different insulation, reflectivity and vapour permeability[J]. International Journal of Occupational Safety and Ergonomics, 2010, 16(2): 231-244. |
| [9] | Havenith G, Wang X, Hartog E A, et al.Interaction effects of radiation and convection measured by a thermal manikin wearing protective clothing with different radiant properties [C]// Proceedings of the 3rd International Conference on Human-Environmental System. Tokyo, Japan, 2005:47-50. |
| [10] | Lawson J R, Mell W E, Kuldeep R P. A heat transfer model for firefighters' protective clothing, continued developments in protective clothing modeling[J]. Fire Technology, 2010, 46(4): 833-841. |
| [11] | Howie R. Assessment of the scientific validity of ISO 7933/EN 12515 [C]// 1st European Conference on Protective Clothing. Stockholm, Sweden, 2000: 163-166. |
| [12] | Mandal S, Song G W, Akcerman M, et al.Characterization of textile fabrics under various thermal exposures[J]. Textile Research Journal, 2012, 83(10): 1005-1019. |
),袁宏永
