冯国栋，工学博士，副教授，硕士生导师，中山大学“****”引进人才
中山大学，自动化，学士学位，2010
中山大学，通信与信息系统，博士学位，2015
加拿大温莎大学，博士后研究员，2015-2019
IEEE Senior Member
2015至2019年在加拿大温莎大学新能源实验室研究中心从事面电机系统智能控制研究，作为核心成员参与并完成了多项由加拿大自然科学基金委资助的电机系统智能控制的科研项目，并完成了研究成果的商业化，在研究领域高水平期刊上发表论文超过40篇，以第一/通信作者在IEEE Transactions期刊上发表中科院一区论文18篇，谷歌学术引用800多次，单篇最高被引用69次。获得两项授权专利、一项最佳会议论文奖。
二、学科方向
新能源、氢燃料系统、智能控制、电力电子、电机系统
三、科研项目
2020 – 2022 中山大学****启动经费
2020-2022 广东省粤深联合项目，主持，在研
2021-2023 广东省重点研发计划项目子课题，主持，在研
四、论著专利
代表性期刊论文（*号表示通讯作者）
[1]G. Feng*, C. Lai, X. Tan, B. Wang and N. Kar, "Optimal current modeling and identification for fast and efficient torque ripple minimization of PMSM using theoretical and experimental models," IEEE Transactions on Industrial Electronics, 2021, doi: 10.1109/TIE.2020.**.
[2]G. Feng*, C. Lai, M. Kelly, and N. C. Kar, “Dual three-phase PMSM torque modelling and maximum torque per peak current control through optimized harmonic current injection”, IEEE Transactions on Industrial Electronics, vol. 66, no. 5, pp. 3356-3368, May 2019.
[3]G. Feng*, C. Lai, and N. C. Kar, “An analytical solution to optimal stator current design for PMSM torque ripple minimization with minimal machine losses,” IEEE Transactions on Industrial Electronics, vol. 64, no. 10, pp. 7655-7665, Oct. 2017.
[4]G. Feng*, C. Lai, and N. C. Kar, “A closed-loop fuzzy logic based current controller for PMSM torque ripple minimization using the magnitude of speed harmonic as the feedback control signal,” IEEE Transactions on Industrial Electronics, vol. 64, no. 4, pp 2642-2653, Apr. 2017.
[5]G. Feng*, C. Lai, W. Li, Z. Li and N. C. Kar, "Dual reference frame based current harmonic minimization for dual three-phase PMSM considering inverter voltage limit," IEEE Transactions on Power Electronics, doi: 10.1109/TPEL.2020.**.
[6]G. Feng*, C. Lai, W. Li, Y. Han and N. C. Kar, "Computation-efficient solution to open-phase fault tolerant control of dual three-phase interior PMSMs with maximized torque and minimized ripple," IEEE Transactions on Power Electronics, vol. 36, no. 4, pp. 4488-4499, April 2021.
[7]G. Feng*, C. Lai, W. Li, Z. Li and N. C. Kar, “Efficient permanent magnet temperature modeling and estimation for dual three-phase PMSM considering inverter nonlinearity,” IEEE Transactions on Power Electronics, vol. 35, no. 7, pp. 7328-7340, July 2020.
[8]G. Feng*, C. Lai, W. Li, J. Tjong, and N. C. Kar, “Open-phase fault modeling and optimized fault tolerant control of dual three-phase permanent magnet synchronous machines,” IEEE Transactions on Power Electronics, vol. 34, no. 11, pp. 11116-11127, Nov. 2019.
[9]G. Feng*, C. Lai, J. Tian, and N. C. Kar, "Multiple reference frame based torque ripple minimization for PMSM drive under both steady-state and transient conditions,” IEEE Transactions on Power Electronics, vol. 34, no. 7, pp. 6685-6696, July 2019.
[10]G. Feng*, C. Lai, and N. C. Kar. “Noninvasive Kalman filter based permanent magnet temperature estimation for permanent magnet synchronous machines,” IEEE Transactions on Power Electronics, vol. 33, no. 12, pp. 10673-10682, 2018.
[11]C. Lai, G. Feng*, Z. Li, and N. C. Kar, “Computation-efficient decoupled multiparameter estimation of PMSMs from massive redundant measurements,” IEEE Transactions on Power Electronics, vol. 35, no. 10, pp. 10729-10740, 2020.
[12]C. Lai, G. Feng*, J. Tjong, and N. C. Kar, “Direct calculation of maximum-torque-per-ampere angle for interior PMSM control using measured speed harmonic,” IEEE Transactions on Power Electronics, vol. 33, no. 11, pp. 9744-9752, 2018.
[13]G. Feng*, C. Lai, and N. C. Kar, “Practical testing solutions to optimal stator harmonic current design for PMSM torque ripple minimization using speed harmonics,” IEEE Transactions on Power Electronics, vol. 33, no. 6, pp. 5181-5191, Jun. 2018.
[14]C. Lai, G. Feng*, and K. Mukherjee, V. Loukanov and N. C. Kar, “Torque ripple modeling and minimization for interior PMSM considering magnetic saturation,” IEEE Transactions on Power Electronics, vol. 33, no. 3, pp. 2417-2429, 2017.
[15]G. Feng*, C. Lai, and N. C. Kar, “Speed harmonic based modeling and estimation of permanent magnet temperature for PMSM drive using Kalman filter,” IEEE Transactions on Industrial Informatics, vol. 15, no. 3, pp.1372-1382, Mar. 2019.
[16]C. Lai, G. Feng*, K. Mukherjee, J. Tjong, and N. C. Kar, “Maximum torque per ampere control for IPMSM using gradient descent algorithm based on measured speed harmonics,” IEEE Transactions on Industrial Informatics, vol. 14, no. 4, pp. 1424-1435, Apr. 2018.
[17]G. Feng*, C. Lai, and N. C. Kar, “Particle Filter based magnet flux linkage estimation for PMSM magnet condition monitoring using harmonics in machine speed,” IEEE Transactions on Industrial Informatics, vol. 13, no. 13, pp. 1280-1290, June 2017.
[18]G. Feng*, C. Lai, and N. C. Kar, “Expectation maximization particle filter and Kalman filter based permanent magnet temperature estimation for PMSM condition monitoring using high-frequency signal injection,” IEEE Transactions on Industrial Informatics, vol. 13, no. 3, pp. 1261-1270, June 2017.
更为详细的论文列表见主页：https://www.researchgate.net/profile/Guodong-Feng-3
五、荣誉获奖情况
获得2015年第二届中国智能物联系统会议最佳论文奖
六、联系方式
fenggd6@mail.sysu.edu.cn