小展弦比涡轮叶片的弯曲优化设计

删除或更新信息，请邮件至freekaoyan#163.com(#换成@)

清华大学辅仁网/2017-07-07

小展弦比涡轮叶片的弯曲优化设计

韩俊,温风波,赵广播(

)

Curve optimization design of a turbine blade withlow aspect ratio

Jun HAN,Fengbo WEN,Guangbo ZHAO(

)

Energy Science and Engineering School, Harbin Institute of Technology, Harbin 150001, China

摘要:

HTML
输出: BibTeX | EndNote (RIS) 背景资料

文章导读

摘要该文重点讨论弯扭叶片设计方法在小展弦比的涡轴发动机涡轮叶片设计中的应用,旨在通过多方案的弯曲设计分析具有强二次流动的涡轮叶片的弯曲优化所能带来的气动性能改善和流场结构变化。给出了弯高固定而弯角不同的14个叶片弯曲设计方案。通过数值模拟计算分析了这些方案中总压比和流量,初步得出在该叶片设计中反弯设计要优于正弯和直叶片设计,且反弯15°方案为最优方案。根据密流沿叶高分布图分析了正弯、直和反弯叶片情况的下端区和中间区域的通流能力变化。结合叶片壁面极限流线图和静压分布,可发现反弯情况下造成的反向C型压力分布使得端区流动不但没有改善反而恶化,但是中间区域的低能流体却大大减少,从而总体损失得到减少。从出口截面的总压分布也可看出通道涡尺度变大,造成端区总压损失较大。

关键词 ：涡轮,小展弦比,反弯叶片,通道涡,优化设计

Abstract：The curved blade design method was used in a vortex axis engine turbine with low aspect ratio to analyze the effect of the curved blade optimization on improving the aerodynamic performance and the flow field structure of the turbine blade with strong secondary flow. Design schemes were determined for 14 curved blades with fixed height and different corners, with the total pressure ratio and flow then obtained through numerical calculation. Preliminary results showed that the negative curved blade prototype is superior to the positive and straight blades, and that the scheme with inflection of 15° is the optimal solution. The changes of the flow ability in the bottom area and the middle area were given based on the density flow along the blade height. Combination of the blade wall limit flow and the static pressure distribution shows that the reverse C type pressure distribution caused by the negative curved blade deteriorates the end zone flow but with low energy fluid in the middle areas greatly reduced, so the overall losses are reduced. The total pressure distribution on the outlet section also shows that the total pressure loss in the end areas increases with increasing passage vortex scale.

Key words：turbine low aspect ratio negative curved blade passage vortex optimization design

收稿日期: 2013-10-09 出版日期: 2015-04-16

ZTFLH:

基金资助:国家自然科学基金青年科学基金项目(51206034)

引用本文:

韩俊, 温风波, 赵广播. 小展弦比涡轮叶片的弯曲优化设计[J]. 清华大学学报（自然科学版）, 2014, 54(1): 102-108.
Jun HAN, Fengbo WEN, Guangbo ZHAO. Curve optimization design of a turbine blade withlow aspect ratio. Journal of Tsinghua University(Science and Technology), 2014, 54(1): 102-108.

链接本文:

http://jst.tsinghuajournals.com/CN/或 http://jst.tsinghuajournals.com/CN/Y2014/V54/I1/102

图表:

弯叶片积迭线形式

叶片	弯角/ (°)
反弯叶片	-20	-18	-17	-15	-13	-10	-8
正弯叶片	10	15	17	18	20	22	25

不同弯角的弯叶片方案设计

网格及流道形式

实际气体性质

进口参数沿叶高分布

总体参数的变化趋势

出口密流沿相对叶高分布

正弯叶片静压等值线

原型直叶片静压等值线

反弯叶片静压等值线

叶片出口总压云图

参考文献:

[1]	Wang Z, Lai S, Xu W. Aerodynamic calculation of turbine stator cascades with curvilinear leaned blades and some experimental results [C]// Proceedings of the 5th ISABE. Bangalore, 1981.
[2]	WANG Zhongqi, HAN Wanjin, XU Wenyuan, et al.The blade curving effects in a turbine stator cascades with low aspect ratio [J]. Journal of Engineering Thermophysics, 1990, 11(3): 255-262.
[3]	Wang Z, Han W, Xu W. An experimental investigation into controlling the secondary flow in turbine cascade with leaned blade and divergent outer wall [C]// Proceedings of IGTI. 87-IGCT-18.
[4]	HAN Wanjin, CAI Daying, XU Wenyuan, et al.An experimental study of effect of endwalls’ and blade surfaces’ static pressure distribution on cascade aerodynamic characters[J]. Journal of Engineering Thermophysics, 1989, 10(3): 273-276.
[5]	Wang Z, Xu W, Han W. An experiment investigation into the influence of the blade leaning on the secondary flow in annular cascade with small diameter-length ratio[R]. ASME 85-wam-1485.
[6]	Breugelmans F AH, Carels Y. Influence of dihedral on the secondary flow in two dimensional compressor cascade[J]. Journal of Engineering for Gas Turbine and Power, 1984, 106(3): 578-584.
[7]	Wang Z, Han W. The effectof blade curving on flow characteristics in rectangular turbine stator cascade with different incidence [R]. ASME 91-GT-60.
[8]	Wang Z, Han W. An experimental investigation into the influence of diameter-blade height ratios on secondary flow loss in annular cascade with leaned blade [R]. ASME 87-GT-131.
[9]	Han W, Tan Q, Wang Z. The control of secondary flow by combingthe convergent endwall with lean blade[J]. Journal of Engineering Thermophysics, 1990, 3(3): 310-318.
[10]	Wang Z, Su J, Zhong J. The effect of the pressure distribution in a three dimensional flow field of a cascade on the type of curved blade [R]. ASME 94-GT-409.
[11]	FENG Guotai, SU Jiexian, WANG Zhongqi, et al.The application of synthesized optimizing flow pattern to blade profiling and design[J].Journal of Engineering Thermophysics, 1991, 12(2): 156-159.
[12]	WEN Fengbo, WANG Songtao, FENG Guotai, et al.Multilevel turbine aerodynamic optimization design system with coolant mixing[J].Journal of Engineering Thermophysics, 2008, 29(8): 1301-1306.
[13]	FENG Guotai, GU Zhonghua, WEN Fengbo, et al.Aerodynamic design system & ideology of air-cooled turbine and its application to gas turbines[J]. Journal of Engineering Thermophysics, 2009, 30(11): 1841-1848.
[14]	LI Haibin, FENG Guotai, CHEN Fu. Flow field structure analysis in straight and bowed turbine vanes under cooling air mixture[J]. Journal of Propulsion Technology, 2003, 24(2): 125-129.
[15]	LU Shaopeng, CHI Zhongran, WEN Fengbo, et al.Multi-objective optimization of turbine blades considering film cooling[J]. Journal of Engineering Thermophysics, 2013, 34(6): 1036-1041.
[16]	LU Shaopeng, CHI Zhongran, WANG Songtao, et al.Three-dimensional optimization of turbine blades considering film cooling[J]. Journal of Propulsion Technology, 2013, 34(5): 614-619.

[1]	王振波, 张君, 罗孙一鸣. 喷水法成型纤维网增强水泥基板材抗弯性能[J]. 清华大学学报（自然科学版）, 2014, 54(5): 551-555.
[2]	田志宏, 姜伟, 张宏莉. 一种支持犯罪重现的按需取证技术[J]. 清华大学学报（自然科学版）, 2014, 54(1): 20-28.
[3]	谢丰, 彭勇, 赵伟, 高洋, 王得金, 韩雪峰. 工业控制设备安全测试技术[J]. 清华大学学报（自然科学版）, 2014, 54(1): 29-34.
[4]	马刚, 杜宇鸽, 荣江, 甘家瑞, 史忠植, 安波. 基于威胁传播的复杂信息系统安全风险评估[J]. 清华大学学报（自然科学版）, 2014, 54(1): 35-43.
[5]	董国伟, 郭涛, 张普含, 贾依真. 基于路径分析和迭代蜕变测试的Bug检测[J]. 清华大学学报（自然科学版）, 2014, 54(1): 60-67.
[6]	王得金, 江常青, 彭勇. 工业控制系统上基于安全域的攻击图生成[J]. 清华大学学报（自然科学版）, 2014, 54(1): 44-52.
[7]	王志华, 庞海波, 李占波. 一种适用于Hadoop云平台的访问控制方案[J]. 清华大学学报（自然科学版）, 2014, 54(1): 53-59.
[8]	李轶. 多相流测量技术在海洋油气开采中的应用与前景[J]. 清华大学学报（自然科学版）, 2014, 54(1): 88-96.
[9]	梁洪亮, 阳晓宇, 董钰, 张普含, 刘书昌. 并行化智能模糊测试[J]. 清华大学学报（自然科学版）, 2014, 54(1): 14-19.
[10]	吴贵清, 葛楠, 杨安, 李和平, 包成玉. 压力对双射流电弧等离子体特性的影响[J]. 清华大学学报（自然科学版）, 2014, 54(1): 68-72.
[11]	王志斌, 陈国旭, 王哲, 葛楠, 李和平, 包成玉. 三电极非热电弧发生器放电模式的实验研究[J]. 清华大学学报（自然科学版）, 2014, 54(1): 73-77.
[12]	刘子玉, 蔡坚, 王谦, 程熙云, 石璐璐. 硅晶圆上窄节距互连铜凸点[J]. 清华大学学报（自然科学版）, 2014, 54(1): 78-83.
[13]	李京哲, 梁彬, 游伟, 王鹏, 石文昌. 基于控制依赖分析的Android远程控制类恶意软件检测[J]. 清华大学学报（自然科学版）, 2014, 54(1): 8-13.
[14]	雷涛, 向天宇, 陆安江, 彭嫚, 张正平. 开路支节加载的双模滤波器设计[J]. 清华大学学报（自然科学版）, 2014, 54(1): 84-87.
[15]	方朝纲, 宋蔷, 仲蕾, 熊刚, 姚强. 重力场作用下三种不同燃料液滴在垂直电场中的燃烧特性[J]. 清华大学学报（自然科学版）, 2014, 54(1): 97-101.