qzhang@tju.edu.cn
工程力学
无
教授
散体-连续体耦合系统动力学仿真关键技术研究

---

基于强非线性思想的DNA弹性杆微观几何形态与稳定性分析

---

高维强非线性复杂系统动力学行为研究

---

索结构风致振动的非线性动力学研究

---

隧道风机振动与噪声控制与风机叶轮部强度计算分析

---

基于尖端放电及边缘效应的微梳状驱动器复杂动力学问题研究

---

发酵罐裂纹损伤机理及治理方案研究

---

货车疲劳试验技术研究─C70E型通用敞车模态理论计算方法研究

---

福建福清核电厂5、6号机组项目VNA系统排风烟囱力学计算及抗震分析

---

微机电系统的复杂动力学与控制理论应用

---

华能山东石岛湾核电厂高温气冷堆核电站示范工程通风系统排风烟囱力学计算及抗震分析

---

混联机轴断裂的故障诊断

我国高速重载货车的发展和非线性动力学研究

---

三自由度横向补给系统高架索的面内振动

---

横向补给系统高架索的动力学研究

---

二维非线性振动系统同异宿轨道的类Pade逼近方法

---

Spatially complex localization in twisted elastic rods constrained to an elliptic cylinder

---

非圆截面弹性细杆模型简化方法研究

---

用改进的Pade法计算一类具有偶次非线性项的自治振动方程的解析同宿及异宿轨道

---

Measurement of the Young's modulus using micro-cantilevered beam actuated by electrostatic force

---

Influence of sense stiffness nonlinearity on the sensitivity stability of a double-sense micro-gyroscope

---

Mechanical behaviors of electrostatic microresonators with initial offset imperfection: qualitative analysis via time-varying

---

Stability and perturbation analysis of a one-degree-of-freedom doubly clamped microresonator with delayed velocity feedback c

---

Nonlinear coupled vibration of electrostatically actuated clamped–clamped microbeams under higher-order modes excitation

---

Wideband quin-stable energy harvesting via combined nonlinearity

---

Fuzzy Fractional-Order Fast Terminal Sliding Mode Control for Some Chaotic Microcomponents

---

Low-frequency wideband vibration energy harvesting by using frequency up-conversion and quin-stable nonlinearity

---

Nonlinear dynamics behavior analysis of the spatial configuration of a tendril-bearing plant

---

Chaos Suppression of an Electrically Actuated Microresonator Based on Fractional-Order Nonsingular Fast Terminal Sliding Mode

---

Nonlinear dynamic analysis of electrically actuated viscoelastic bistable microbeam system

---

Dynamic analysis and design of electrically actuated viscoelastic microbeams considering the scale effect

---

Stability prediction for milling process with multiple delays using an improved semi-discretization method

---

A New Approach of Asymmetric Homoclinic and Heteroclinic Orbits Construction in Several Typical Systems Based on the Undeterm

---

散体与连续体耦合系统的模态特性实验

---

Bifurcation control of an electrostatically-actuated MEMS actuator with time-delay feedback

---

时滞控制下的微梳状驱动器动力学研究

---

缓冲结构对静电驱动微桥动力学特性的影响

---

Analytical solution of earth pressure on supporting structure of deep foundation pit considering arching effects

---

Helical configurations of elastic rods in the presence of interfacial traction

---

考虑土拱效应平移挡土墙地震主动土压力分布

---

压膜阻尼作用下微机械谐振器动力学分析

---

Static bifurcation and primary resonance analysis of a MEMS resonator actuated by two symmetrical electrodes

---

Nonlinear Dynamic Analysis of Railway Wagon End Wall under the Action of Granular Media

---

Design considerations on large amplitude vibration of a doubly clamped microresonator with two symmetrically located electrod

---

考虑转向架影响的重载货车车厢模态特性

---

Equilibrium Configurations of the Noncircular Cross-Section Elastic Rod Model with the Elliptic KB Method

---

一种求解短型挡土墙主动土压力的解析方法

---

Stability prediction of milling process with variable pitch and variable helix cutters

---

基于强几何非线性因素的覆冰导线舞动问题研究

---

覆冰导线连续体非线性动力学行为研究

---

模型修正技术在螺栓连接结构中的应用探讨

---

The Combined Internal and Principal Parametric Resonances on Continuum Stator System of Asynchronous Machine

---

Comment on Modulating DNA configuration by interfacial traction: an elastic rod model to characterize DNA folding and unfoldi

---

内燃机曲轴系统变惯量公式的修正

---

模型修正技术在螺栓连接结构中的应用探讨

---

Comment on "Modulating DNA configuration by interfacial traction: an elastic rod model to characterize DNA folding and unfold

---

A continuum model for condensation of DNA in solution

---

Lateral Earth Pressure behind Walls Rotating about Base considering Arching Effects

---

1439. Numerical simulation of the magnetic field and electromagnetic vibration analysis of the AC permanent-magnet synchronou

---

A frequency-domain solution for efficient stability prediction of variable helix cutters milling

---

Prediction Chatter Stability and Bifurcation in Milling Machine

---

Analytical Reduction of the Non-circular Kirchhoff Elastic rod Model with the Periodically Varying Bending Rigidities

---

非对称截面环状Kirchhoff 弹性细杆的拓扑构型分析

---

覆冰输电线非线性瞬时固有频率研究

---

Stability analysis for variable spindle speed milling with helix angle using an improved semi-discretization method

---

Homoclinic orbits in three-dimensional Shilnikov-type chaotic systems

---

非对称截面环状Kirchhoff弹性细杆的拓扑构型分析

---

Stability prediction of milling process with variable pitch cutter

---

变惯量曲轴系统扭转振动参数分岔分析

---

Thick crescent iced sub-conductors spacing influence on the aerodynamic properties

---

Chaos of several typical asymmetric systems

---

薄壁圆柱壳在流体脉动激励下的振动特性分析

---

Stability predictions of milling with variable spindle speed using an improved semi-discretization method

---

高余维退化Hopf分岔系统的最简规范形

---

Hopf bifurcation for delay differential equation with application to machine tool chatter

---

非对称截面Kirchhoff弹性细杆模型简化方法研究

---

强非线性振动系统的通用化求解程序及应用

---

类Pade逼近方法在二维非线性振动系统的应用

---

覆冰四分裂输电线舞动研究