关键词: 再发射率/
金泡沫/
黑腔/
辐射烧蚀
English Abstract
Experimental study on improving hohlraum wall reemission ratio by low density gold foam
Zhang Lu,Dong Yun-Song,
Jing Long-Fei,
Lin Zhi-Wei,
Tan Xiu-Lan,
Kuang Long-Yu,
Li Hang,
Shang Wan-Li,
Zhang Wen-Hai,
Li Zhi-Chao,
Zhan Xia-Yu,
Yuan Guang-Hui,
Li Hai,
Jiang Shao-En,
Yang Jia-Min,
Ding Yong-Kun
1.Research Center of Laser Fusion, China Academy of Engineering Physics, Mianyang 621900, China
Fund Project:Project supported by the National Natural Science Foundation of China (Grant No. 11305158).Received Date:30 March 2015
Accepted Date:16 October 2015
Published Online:05 January 2016
Abstract:It is important to improve the hohlraum radiation temperature for the research of high energy density physics, especially for study of inertial confinement fusion. Increasing the wall reemission ratio is an effective way to improve the temperature. It is found in theory that low density foam could reduce hohlraum wall energy loss, and then increase hohlraum temperature. In previous studies, experiments have shown that laser-to-X-ray conversion is enhanced by Au foam. However, improving reemission ratio is more important to increase hohlraum radiation temperature, because most of energy is lost in the wall.In this paper, we report our experiments carried out on SGⅢ prototype to compare the X-ray flux reemitted by Au foam and that by Au. For the experimental design, Au solid and Au foam are irradiated symmetrically along the axis by hohlraum radiation source Tr(t), which is assessed by broadband X-ray spectrometer flat-response X-ray diodes. The measured peak temperature is about 190 eV. Reemission flux from sample is measured by transmission grating spectrometer (TGS). The space-resolved image for pure Au sample shows that the hohlraum radiation is asymmetrical along the axis in the experimental conditions, temperature of top is higher than that at the bottom, which is consistent with simulation results obtained by using IRAD3D code. In order to compare the reemission flux from Au solid sample and that from Au foam sample in same conditions, we need to correct the symmetry of hohlraum radiation. By multiplying the ratio of top flux to bottom flux in pure Au target by the bottom flux in Au-Au foam target, where Au foam is on, we make sure that they are ablated by the same radiation source. The calculated results show that X-ray flux is increased by 20% by Au foam of 0.4 g/cc density when the hohlraum temperature is 190 eV. The typical observed time-integrated X-ray reemission spectra for Au solid and Au foam by TGS are also shown. We see that N-band and O-band reemission are clearly enhanced by Au foam, and the O-band reemission is almost the same as M-band reemission. The increased flux concentrates below 1 keV of the soft X-ray emission.The self-similar solution results and MULTI 1D simulation results show that the wall loss energy fraction is saved by Au foam, whose relation to reemission flux can be described by a simple expression. The theoretical solution shows that the emission flux increases about 10%, and the MULTI simulation indicates that the emission flux increases about 6.8%. They are in qualitative agreement with the experiments results. These results show an alluring prospect for Au foam to be used as hohlraum wall.
Keywords: reemission ratio/
Au foam/
hohlraum/
radiation ablate
