DOI: 10.11908/j.issn.0253-374x.20475

作者:

作者单位: 1.同济大学 土木工程学院，上海 200092;2.宁波交通工程建设集团有限公司，浙江 宁波 315000


作者简介: 邹 宇（1987—），男，博士生，主要研究方向为装配式桥梁结构的设计与施工、桥梁结构智能设计与建造。 E-mail： zoyu@tongji.edu.cn


通讯作者: 徐 栋（1966—），男，教授，博士生导师，工学博士，主要研究方向为混凝土桥梁、桥梁轻型化快速建造技术。 E-mail： xu_dong@tongji.edu.cn

中图分类号: U443.35


基金项目: 国家自然科学基金（52078363）




Mechanical Characteristics of Steel Keyed Joints of Precast Segmental Bridge
Author:

Affiliation: 1.College of Civil Engineering，Tongji University，Shanghai 200092，China;2.Ningbo Communication Engineering Construction Group Co， Ltd.，Ningbo 315000，China


Fund Project:




摘要
| 图/表
| 访问统计
| 参考文献
|相似文献
| 引证文献
| 资源附件

摘要:设计2个接缝直剪试验，并结合数值分析对钢榫键接缝在施工阶段和成桥阶段的受力特性进行分析。结果表明：在侧限压力的作用下钢榫键接缝依靠钢材和混凝土的接触受压来传递接缝间的剪力，接缝具有较高的抗剪承载力和良好的延性，当荷载?位移曲线进入水平段后，接缝仍能承受较大的相对变形，并保持承载力不降低；在施工阶段应由钢榫键跨缝齿的非弹性变形对临时荷载进行控制设计，在成桥阶段应由钢榫键材料剪切强度对接缝直剪强度进行控制设计；钢榫键接缝直剪抗力可按剪切实用公式计算，钢榫键材料和跨缝齿直径均是影响钢榫键接缝承载力的关键因素。



Abstract:Two direct shear experiments were designed， and the mechanical characteristics of steel keyed joints in the construction and service stage were analyzed with a combination of numerical analysis. It is shown that the joints depend on the contact compression between steel and concrete to transfer the shear force between the joints under the action of confining stress. The joints have high shear bearing capacity and good ductility. When the load-displacement curve enters the horizontal section， the joints can still bear large relative deformation， and its bearing capacity does not decrease. In the construction stage， the inelastic deformation of crossing-joint teeth should be used to control the temporary load design. In the service stage， the direct shear strength of the joints should be controlled by the shear strength of steel key’s material. The direct shear resistance of steel keyed joints can be calculated according to the shear formula. The material of the keys and the diameter of the crossing-joint teeth are the key factors affecting the bearing capacity of the joints.





PDF全文下载地址:

点我下载PDF