吴昊，易培云，彭林法，来新民

上海交通大学 机械系统与振动国家重点实验室， 上海 200240

通讯作者:来新民，男，教授，博士生导师，电话 (Tel.): 021-34206303; E-mail: xmlai@sjtu.edu.cn.
作者简介:吴昊(1987-），男，湖南省常德市人，博士生，主要研究方向为聚合物微细结构成型.

Numerical Analysis of the UV Curing and Demolding Process for High Aspect Ratio Micro Structure

WU Hao,YI Peiyun,PENG Linfa,LAI Xinmin

State Key Laboratory of Mechanical System and Vibration, Shanghai Jiao Tong University, Shanghai 200240, China

摘要/Abstract

摘要： 针对高深宽比结构的脱模问题，利用压缩试验获得了材料的力学性能，并用Ogden模型对其进行描述，建立了卷对卷紫外光(UV)固化-脱模工艺过程的有限元模型.分析了光照时长、残余层厚度、微结构深宽比以及结构间隙等参数对脱模最大应力的影响规律.结果表明：在结构深宽比为4∶1时，界面粘接力是导致脱模缺陷的主要原因；光照时长越长，残余层厚度越薄；微结构深宽比越小以及结构间隙越大，固化-脱模应力越小、越有利于脱模.
关键词: 高深宽比, 卷对卷, 固化-脱模, 结构缺陷
Abstract: Focusing on the demolding issues of high aspect ratio structures, this paper attempts to explain the reasons behind this problem. Firstly, the material properties of the cured resist was measured, and Ogden model was used to describe its behavior. Then, a roll to roll UV curing and demolding numerical model was constructed and analyzed. It was found that the adhesive forces between mold and structures is the major cause of maximum stress in cured resist when aspect ratio is set to 4∶1. Moreover, a longer curing time, a thinner residual layer thickness, a smaller structure aspect ratio and a bigger structure gap can lead to smaller maximum stress during the curing and demolding process.
Key words: high aspect ratio, roll to roll, curing and demolding, structure defects


PDF全文下载地址:

点我下载PDF