关键词: 四波混频/
光学计算/
非相敏放大/
误差矢量幅度
English Abstract
Principle and noise performance of optical phase arithmetic devices using four wave mixing
Cao Ya-Min,Wu Bao-Jian,
Wan Feng,
Qiu Kun
1.Key Laboratory of Optical Fiber Sensing and Communication, Ministry of Education, School of Communication and Information Engineering, University of Electronic Science and Technology of China, Chengdu 611731, China
Fund Project:Project supported by the National Natural Science Foundation of China (Grant Nos. 61671108, 61505021).Received Date:12 December 2017
Accepted Date:03 January 2018
Published Online:05 May 2018
Abstract:The existing theoretical equations cannot provide an excellent guidance for developing four-wave mixing (FWM)-based optical logic devices, though the experiments have been done in several researches. The optimization of noise figure performances of such devices should be further investigated. In the paper, the universal analytic expressions for the amplitude and phase of the idler in degenerate or non-degenerate FWM process under pump depletion are derived in detail from the nonlinear coupled-mode equations for guiding optical waves propagation in highly nonlinear fiber. The universal analytic expressions are obtained by the first-and the third-kind of elliptic integrals. By using equivalent infinitesimal to calculate the limit of phase sensitive amplification, we find out the initial phase relationship between the idler and the input guided wave for phase-independent amplification, which is crucially important for explaining the operating principles of the FWM-based adder and subtracter. As an example, the configuration of non-degenerate FWM-based hybrid arithmetic device with three logic functions of A+B-C, A+C-B, and B+C-A for QPSK signals is presented, and then the noise transfer characteristics in terms of signal-to-noise ratio (SNR) and error vector magnitude (EVM) are taken into account by adjusting the fiber length, input wavelength, and optical power. The calculation results show as follows. 1) This kind of arithmetic device has a noise figure of about 1.1 dB and an input SNR of more than 24 dB is necessary for the symbol error rate of 10-3 without forward error correction, corresponding to an output EVM of 23.2%. 2) The length of highly nonlinear fiber used in the hybrid arithmetic device may be taken flexibly, provided that the variation of FWM conversion efficiency is controlled in a range of 1 dB relative to the maximum, with an EVM fluctuation of less than for the idlers. 3) The hybrid arithmetic device has an operating optical bandwidth of about 16 nm for the SNR degradation of 1.3 dB. 4) The output EVM increases with the increase of input power, and the allowable input power should be no more than 100 mW for an input SNR of 28 dB, noting that the larger the input SNR, the higher the allowable input power is.
Keywords: four-wave mixing/
optical computing/
phase independent amplifier/
error vector magnitude