DOI: 10.11908/j.issn.0253-374x.19542

作者:

作者单位: 1.同济大学 汽车学院，上海 201804;2.同济大学 新能源汽车工程中心，上海 201804;3.同济大学 机械工程流动站，上海 201804


作者简介: 熊 璐(1978—)，男，教授，博士生导师，工学博士，主要研究方向为车辆系统动力学与控制.E-mail: xiong_lu@tongji.edu.cn


通讯作者: 冷 搏(1991—)，男，博士后，工学博士，主要研究方向为车辆系统动力学与控制.E-mail: harrisonleng@gmail.com

中图分类号: U463.52


基金项目: 国家重点研发计划 (2018YFB0105804)




Wheel-Cylinder Hydraulic Pressure Control of Integrated-Electro-Hydraulic Brake System Without Pressure Sensors
Author:

Affiliation: 1.School of Automotive Studies, Tongji University, Shanghai 201804, China;2.Clean Energy Automotive Engineering Center, Tongji University, Shanghai 201804, China;3.Postdoctoral Station of Mechanical Engineering, Tongji University, Shanghai 201804, China


Fund Project:




摘要
| 图/表
| 访问统计
| 参考文献
|相似文献
| 引证文献
| 资源附件

摘要:线控电子液压制动系统作为下一代汽车制动系统的主流解决方案，其轮缸液压力控制是实现车辆稳定性控制等主动安全功能的基础。针对四阀结构的集成式电子液压制动系统的成本与冗余问题，提出一种无轮缸压力传感器下的轮缸液压力控制策略。通过台架测试分析液压调节单元的工作特性，提出基于伯努利方程与轮缸PV(pressure volume)特性相结合的轮缸液压力估计方法，设计电磁阀开闭逻辑及基于减压优先的轮缸液压力均衡控制策略，最后通过台架试验进行对比验证。试验结果表明，所提出方法的液压力控制均方根误差在0.21MPa以内，与有液压力传感器方案的控制精度相当。



Abstract:The electro-hydraulic brake-by-wire system is the mainstream solution for next-generation automotive brake systems, whose wheel-cylinder hydraulic pressure control is the basis to achieve active safety functions such as vehicle stability control. In view of the cost and redundancy of the integrated-electronic-hydraulic brake system with a four-valve structure, a wheel-cylinder hydraulic pressure control strategy without pressure sensors is proposed. Through the bench test, the working characteristics of the hydraulic control unit were analyzed. A method for estimating the hydraulic pressure of the wheel cylinder is developed based on the combination of Bernoulli equation and PV characteristics. The solenoid-valve control logic and balance control strategy are designed for wheel-cylinder pressure regulation based on depressurization priority. The experimental results show that the root-mean-square error of the pressure control in this method is within 0.21MPa, which is equivalent to the control accuracy of the scheme with a hydraulic pressure sensor.





PDF全文下载地址:

点我下载PDF