DOI: 10.11908/j.issn.0253-374x.2018.02.002

作者:

作者单位: 同济大学,同济大学,同济大学建筑设计研究院(集团)有限公司


作者简介:


通讯作者:

中图分类号: TU375.1


基金项目: 国家重点研发计划项目（2016YFC0700700）




Shear behavior analysis of concrete beams reinforced with 500 MPa stirrups under indirect load
Author:

Affiliation:


Fund Project:




摘要
| 图/表
| 访问统计
| 参考文献
|相似文献
| 引证文献
| 资源附件

摘要:对3根配置500 MPa箍筋的混凝土梁进行间接加载试验,分析了高强箍筋混凝土梁的受力性能、斜裂缝开展情况以及破坏形态。结合ABAQUS有限元软件研究了剪跨比和配箍率对试验梁抗剪承载力的影响。研究表明,《混凝土结构设计规范》能很好地预测配置500 MPa箍筋混凝土梁在直接加载作用下的抗剪承载力；间接加载梁与直接加载梁相比,抗剪承载力有一定程度的降低,降低因素主要为剪跨比和配箍率；规范中附加横向配筋的构造要求可以有效补偿间接加载作用下高强箍筋梁抗剪承载力的降低。



Abstract:A test of three concrete beams with 500MPa high-strength stirrups under indirect load was performed to analyze the structural behaviors, the development of the diagonal cracks and failure modes under direct and indirect load. Numerical models were established with ABAQUS to study the effect of shear span ratio and stirrup ratio on the shearing capacity of the tested beams. The results show that the shearing capacity of high-strength concrete beams under direct load can be precisely predicted with the ’Code for design of concrete structures’. Moreover, the shearing capacity of the beams under indirect load decreases compared with the beams under direct load due to the variation of the shear span ratio and the stirrup ratio. The detailing requirements of additional transverse reinforcement as the code puts can effectively compensate the shearing capacity reduction of the high-strength stirrups beam under indirect load.





PDF全文下载地址:

点我下载PDF