| 赵庆红,郭俊卿,陈拂晓,张信民.FDM工艺缝隙模型及消除方法研究[J].,2018,58(1):38-42 |
| FDM工艺缝隙模型及消除方法研究 |
| Research on gap model and elimination method in FDM process |
|
| DOI：10.7511/dllgxb201801006 |
| 中文关键词:熔融沉积成型缝隙熔合模型光栅角度路径宽度 |
| 英文关键词:fused deposition modelinggap fusion modelraster anglefill path width |
| 基金项目:河南省基础与前沿技术研究计划资助项目(162300410211)；中国博士后科学基金资助项目(2016M590677). |
|
| 摘要点击次数:951 |
| 全文下载次数:1130 |
| 中文摘要: |
| 熔融沉积成型作为一种成本低、稳定性高的快速成型工艺，在三维模型制造和新产品开发领域的应用不断扩大．针对熔融沉积成型制件中光栅线与轮廓线之间出现的缝隙，分析了其产生的原因并建立了缝隙熔合模型．将理论计算与实验结果进行对比，研究了光栅角度、路径宽度对缝隙面积的影响，获得了光栅角度θ∈［0°，90°］时缝隙面积的变化规律，提出了减小孔状缝隙、避免线状缝隙产生的解决方案，为合理选择光栅角度和路径宽度，改善制件质量提供了科学依据． |
| 英文摘要: |
| As a rapid prototyping technology with low cost and high stability, the application of FDM (fused deposition modeling) process is increasing in the field of three dimensional model manufacturing and new product development. The gap fusion model is established for the gap among rasters and contours according to its generation mechanism, and then the theoretical calculation is compared with the experimental results. The conclusion points out the influence of raster angle and fill path width to gap area. Variation regularity of gap area affected by raster angle (θ∈［0°,90°］) is analyzed detailedly. Solutions to reduce the poroid gap and avoid the threadlike gap are indicated, which have directive significance to choose reasonable raster angle and fill path width and improve the quality of FDM parts. |
| 查看全文查看/发表评论下载PDF阅读器 |
| --> | 关闭 |
优惠券领取后72小时内有效，10万种最新考研考试考证类电子打印资料任你选。涵盖全国500余所院校考研专业课、200多种职业资格考试、1100多种经典教材，产品类型包含电子书、题库、全套资料以及视频，无论您是考研复习、考证刷题，还是考前冲刺等，不同类型的产品可满足您学习上的不同需求。 ...考试优惠券 本站小编 Free壹佰分学习网 2022-09-19