1、基本情况

姓名：翟明
性别：男
民族：汉
籍贯：河南南阳
职称：教授
导师类型：硕士生导师

2、教育背景

2009－2010，美国犹他大学，材料科学与工程系，访问****
2005－今， 郑州大学，橡塑模具国家工程研究中心，教师
2002－2005，新加坡南洋理工大学，机械与制造工程学院，研究员
1998－2002，大连理工大学，工程力学系，博士

3、研究领域

成型工艺力学，计算力学，最优化设计

4、荣誉奖励

河南省教育厅学术技术带头人，河南省高等学校青年骨干教师，河南青年五四奖章

5、学术成果

在国内外重要学术期刊上发表论文四十余篇，出版著作二部。代表性论文：
（1）Optimization of Runner Sizes and Process Conditions Considering Both Part Quality and Manufacturing Cost in Injection Molding. Journal of Polymer Engineering, 2011, 31(6-7): 489–494.
（2）Molecular Dynamics Simulation of Bubble Nucleation in Carbon Dioxide/Hexadecane Solution as an Analog to Foaming of Polyethylene by Super Critical Carbon Dioxide. Journal of Plastic Film and Sheeting, 2011, 27(1-2): 117-126.
（3）A Study of Gate Location Optimization of Plastic Injection Molding Using Sequential Linear Programming. International Journal of Advanced Manufacturing Technology, 2010, 49(1): 97-103.
（4）A Numerical Simulation of Full-Shot Microcellular Injection Molding. Journal of Polymer Engineering, 2009, 29(7): 441-453.
（5）Runner sizing in multiple cavity injection mould by non-dominated sorting genetic algorithm. Engineering with Computers, 2009, 25(3): 237-245.
（6）Runner Sizing and Weld Line Positioning for Plastic Injection Moulding with Multiple Gates. Engineering with Computers, 2006, 21(3): 218 – 224.
（7）An Optimization Scheme Based on Flow Resistance to Locate Optimum Gate of Complex Part. Journal of Reinforced Plastics and Composites, 2005, 24(15): 1559-1566
（8）An Improved Algorithm for the Simulation of Injection Molding Filling Process. Journal of Reinforced Plastics and Composites, 2005, 24(7), 691-698
（9）Algorithms for Two Gate Optimization in Injection Molding. International Polymer Processing, 2005, 20(1), 14-18
（10）Algorithm to Optimize Number of Gates and Locations in an Injection Mould. Plastics, Rubber and Composites: Macromolecular Engineering, 2004, 33(8), 330-334