黄瑞敏1,
谢春生2,
陈磊1,
张碗林1
1.华南理工大学环境与能源学院,广州 510006
2.肇庆学院环境工程系,肇庆 526061
Preparation of supported nano-CuO/MnO2 catalysts and their catalytic performance for advanced treatment of printing and dyeing wastewater
YANG Jing1,,HUANG Ruimin1,
XIE Chunsheng2,
CHEN Lei1,
ZHANG Wanlin1
1.College of Environment and Energy, South China University of Technology, Guangzhou 510006, China
2.Department of Environmental Engineering, Zhaoqing University, Zhaoqing 526061, China
-->
摘要
HTML全文
图
参考文献
相关文章
施引文献
资源附件
访问统计
摘要:以酸改性凹凸棒土(ATP)为载体,活性炭为添加剂,制备负载铜、锰过渡金属氧化物的凹凸棒土-活性炭催化剂。以印染废水生化处理后出水的COD和色度为处理对象,考察了不同的催化氧化条件,即凹凸棒土与活性炭的比例、pH、H2O2和催化剂的投加量对印染废水深度处理效果,并利用SEM、XRD对催化剂进行表征。结果表明:在室温25 ℃时,催化剂载体中凹凸棒土与活性炭的比例为2∶1,H2O2加入量为理论加入量的2倍,即2.4 mL·L-1,pH值为4,催化剂的使用量为15 g·L-1时,COD和色度的去除率最佳,分别达到93%和90%。扫描电镜结果表明铜、锰以颗粒的形式负载在催化剂的表面,XRD结果表明在催化剂载体表面,活性组分的存在形式为CuO、MnO2。
关键词: 凹凸棒土/
活性炭/
负载/
CuO/MnO2催化剂/
印染废水
Abstract:The copper-manganese oxide catalysts supported on acid modified attapulgite (ATP) and activated carbon were prepared by a method of impregnation. The COD and color of dyeing wastewater secondary effluent were chosen as the treated object. The effects of the proportion of ATP and activated carbon, pH values as well as the dosage of H2O2 and the catalyst on the elimination efficiency of treated object were investigated. The structural properties of catalysts were characterized by SEM and XRD.The results showed that the COD and color reached the best removal efficiency which were 93% and 90%, respectively, when the temperature was 25 ℃, the ratio of ATP and activated carbon of 2∶1, the amount of H2O2, two times of the theoretical amount, pH of 4, and catalyst dosage of 15 g·L-1. The copper and manganese oxides were dispersed on the surface of the catalysts in the form of nano particles and the active components were CuO and MnO2.
Key words:attapulgite/
activated carbon/
support/
CuO/MnO2 catalyst/
dyeing wastewater.
| [1] | 程家迪,蒋路平,罗金飞,等.印染废水深度处理及中水回用技术现状[J].染整技术,2014,36(11):5-9 |
| [2] | 竹湘锋,奚胜兰,徐新华.邻氯苯酚废水Fenton氧化反应动力学研究[J].浙江大学学报(理学版),2004,31(6):669-673 |
| [3] | 陈红,李响,薛罡,等.当前印染废水治理中的关键问题[J].工业水处理,2015,35(10):16-19 |
| [4] | 陈海峰,竹湘锋,徐新华.活性红印染废水的光助Fenton氧化-生化组合处理[J].环境污染与防治,2004,26(2):110-112 |
| [5] | 宿程远,李伟光,刘兴哲,等.以海泡石为载体的双金属多相类芬顿催化剂的制备及表征[J].环境科学,2013,34(9):3513-3519 |
| [6] | 张恒建.柱状凹凸棒石-活性炭负载锰氧化物低温SCR脱硝催化剂性能研究[D].合肥:合肥工业大学,2014 |
| [7] | LI X Y,ZHANG D Y,LIU X Q,et al.A tandem demetalization-desilication strategy to enhance the porosity of attapulgite for adsorption and catalysis[J].Chemical Engineering Science,2016,141(17):184-194 |
| [8] | HUANG J H,LIU Y F,JIN Q Z,et al.Adsorption studies of a water soluble dye,reactive red MF-3B,using sonication-surfactant-modified attapulgite clay[J].Journal of Hazardous Materials,2007,143(1/2):541-548 |
| [9] | CAO J L,SHAO G S,WANG Y,et al.CuO catalysts supported on attapulgite clay for low-temperature CO oxidation[J].Catalysis Communications,2008,9(15):2555-2559 |
| [10] | 阮晨,黄庆.活性炭吸附法去除印染工业废水色度的试验与研究[J].四川环境,2006,25(4):29-34 |
| [11] | LIU W J,YANG T,XU J,et al.Preparation and adsorption property of attapulgite/carbon nanocomposite[J].Environmental Progress & Sustainable Energy,2015,34(2):437-444 |
| [12] | 王宇轩,王应军,方明珠.活性炭负载CuO催化过硫酸盐去除活性艳红X-3B染料[J].环境工程学报,2016,10(1):230-236 |
| [13] | LIU Y S,LIU P,SU Z X,et al.Attapulgite-Fe3O4 magnetic nanoparticles via co-precipitation technique[J].Applied Surface Science,2008,255(5):2020-2025 |
| [14] | 于志新,逯子扬,赵晓红,等.凹凸棒土改性及其在环境水处理中的应用研究[J].硅酸盐通报,2010,29(6):1367-1372 |
| [15] | FAN J,GUO Y H,WANG J J,et al.Rapid decolorization of azo dye methyl orange in aqueous solution by nanoscale zerovalent iron particles[J].Journal of Hazardous Materials,2009,166(2/3):904-910 |
| [16] | CAUDO S,CENTI G,GENOVESE C,et al.Homogeneous versus heterogeneous catalytic reactions to eliminate organics from waste water using H2O2[J].Topics in Catalysis,2006,40(1):207-219 |
| [17] | 戴韵,李俊华,彭悦,等.MnO2的晶相结构和表面性质对低温NH3-SCR反应的影响[J].物理化学学报,2012,28(7):1771-1776 |
Turn off MathJax -->
点击查看大图计量
文章访问数:1413
HTML全文浏览数:991
PDF下载数:458
施引文献:0
出版历程
刊出日期:2018-01-14
-->
负载型纳米CuO/MnO2催化剂的制备及催化氧化深度处理印染废水
杨晶1,,黄瑞敏1,
谢春生2,
陈磊1,
张碗林1
1.华南理工大学环境与能源学院,广州 510006
2.肇庆学院环境工程系,肇庆 526061
基金项目:
关键词: 凹凸棒土/
活性炭/
负载/
CuO/MnO2催化剂/
印染废水
摘要:以酸改性凹凸棒土(ATP)为载体,活性炭为添加剂,制备负载铜、锰过渡金属氧化物的凹凸棒土-活性炭催化剂。以印染废水生化处理后出水的COD和色度为处理对象,考察了不同的催化氧化条件,即凹凸棒土与活性炭的比例、pH、H2O2和催化剂的投加量对印染废水深度处理效果,并利用SEM、XRD对催化剂进行表征。结果表明:在室温25 ℃时,催化剂载体中凹凸棒土与活性炭的比例为2∶1,H2O2加入量为理论加入量的2倍,即2.4 mL·L-1,pH值为4,催化剂的使用量为15 g·L-1时,COD和色度的去除率最佳,分别达到93%和90%。扫描电镜结果表明铜、锰以颗粒的形式负载在催化剂的表面,XRD结果表明在催化剂载体表面,活性组分的存在形式为CuO、MnO2。
English Abstract
Preparation of supported nano-CuO/MnO2 catalysts and their catalytic performance for advanced treatment of printing and dyeing wastewater
YANG Jing1,,HUANG Ruimin1,
XIE Chunsheng2,
CHEN Lei1,
ZHANG Wanlin1
1.College of Environment and Energy, South China University of Technology, Guangzhou 510006, China
2.Department of Environmental Engineering, Zhaoqing University, Zhaoqing 526061, China
Keywords: attapulgite/
activated carbon/
support/
CuO/MnO2 catalyst/
dyeing wastewater
Abstract:The copper-manganese oxide catalysts supported on acid modified attapulgite (ATP) and activated carbon were prepared by a method of impregnation. The COD and color of dyeing wastewater secondary effluent were chosen as the treated object. The effects of the proportion of ATP and activated carbon, pH values as well as the dosage of H2O2 and the catalyst on the elimination efficiency of treated object were investigated. The structural properties of catalysts were characterized by SEM and XRD.The results showed that the COD and color reached the best removal efficiency which were 93% and 90%, respectively, when the temperature was 25 ℃, the ratio of ATP and activated carbon of 2∶1, the amount of H2O2, two times of the theoretical amount, pH of 4, and catalyst dosage of 15 g·L-1. The copper and manganese oxides were dispersed on the surface of the catalysts in the form of nano particles and the active components were CuO and MnO2.
