删除或更新信息,请邮件至freekaoyan#163.com(#换成@)

透水路面-生物滞留池组合道路的城市面源污染控制效果评估

本站小编 Free考研考试/2021-12-31

中文关键词透水路面生物滞留池污染负荷累积冲刷净化效果 英文关键词porous asphaltbio-retentionpollution loadsbuild-upwash-offpurification effect
作者单位E-mail
宫曼莉中国科学院生态环境研究中心城市与区域生态国家重点实验室, 北京 100085
中国科学院大学, 北京 100049
gongmanli_imu@163.com
左俊杰江苏大学环境设计系, 镇江 212000
任心欣深圳市城市规划设计研究院, 深圳 518028
赵洪涛中国科学院生态环境研究中心城市与区域生态国家重点实验室, 北京 100085
中国科学院大学, 北京 100049
htzhao@rcees.ac.cn
罗茜中国科学院生态环境研究中心城市与区域生态国家重点实验室, 北京 100085
中国科学院大学, 北京 100049
廖云杰中国科学院生态环境研究中心城市与区域生态国家重点实验室, 北京 100085
中国科学院大学, 北京 100049
李叙勇中国科学院生态环境研究中心城市与区域生态国家重点实验室, 北京 100085
中国科学院大学, 北京 100049
中文摘要 不同低影响开发(LID)技术组合对于控制城市面源污染具有重要应用价值,但是其对城市面源污染形成过程(污染物累积-冲刷-输送)的影响及污染负荷削减效果的评估鲜见报道.本研究以深圳市国际低碳城为例,分析了6场降雨事件下透水路面-生物滞留池组合对城市面源晴天污染物累积量、降雨径流冲刷量、不同LID设施的削减量、溢流的负荷量的影响.结果表明,研究区地表颗粒物平均累积量为(15.80±3.79)g·m-2,粒径>250 μm的颗粒物质量占比约为65.14%;6场不同强度降雨对地表颗粒物的平均冲刷率为17.15%,粒径<105 μm的颗粒物冲刷率为62.71%~74.94%;降雨冲刷地表径流污染物SS、TN、TP的平均污染负荷分别为2.02、0.025、0.0013 g·m-2;透水路面下渗、过滤作用对污染物SS、TN、TP的去除率分别为70.26%、46.29%、19.27%;生物滞留池对径流二次净化去除率分别为85.25%、20.22%、70.27%;入河径流污染物SS、TN、TP的平均污染负荷分别为0.08、0.011、0.0003 g·m-2,是地表冲刷污染负荷的4.05%、43.47%、24.39%.透水路面-生物滞留池组合应用对道路径流中污染物的净化效果显著.通过定量化表征透水路面-生物滞留池组合应用道路的城市面源污染形成过程,以期为城市面源污染形成过程的污染负荷估算及LID工程绩效评估提供科学依据,为LID在国内的推广应用和海绵城市设计提供参考. 英文摘要 Different combinations of low impact development (LID) technologies can be applied for control of urban non-point source pollution. There are currently few evaluations of urban non-point source pollution and pollution load reduction based on a combination of porous asphalt and bio-retention. Taking Shenzhen International Low Carbon City as an example, road-deposited sediments were collected prior to and after rainfall events. Runoff was monitored under six typical rainfall events, from porous asphalt and the inlet/outlet of bio-retention. Through analysis of changes in the process of "build-up-wash-off-transport" of pollutant loads, the average build-up of road-deposited sediments in the study area was found to be (15.80±3.79) g·m-2; the mass percentage of road-deposited sediments (size>250 μm) was approximately 65.14%. The average wash-off percentage of six different intensity rainfall events was 17.15%, and road-deposited sediments (size<105 μm) were carried by 62.71%-74.94%. The average pollution loads of surface runoff pollutants SS, TN, and TP were 2.02, 0.025, and 0.0013 g·m-2, respectively. The removal rates of SS, TN, and TP through porous asphalt under infiltration and filtration were 70.26%, 46.29%, and 19.27%, respectively. The secondary purification removal rates of runoff water in bio-retention were 85.25%, 20.22%, and 70.27%, respectively. Pollutant loads into Dingshan River totaled 0.08, 0.011, and 0.0003 g·m-2, representing 4.05%, 43.47%, and 24.39% of runoff. The combination thus had a significant effect on runoff purification. Through quantitative research on the formation of non-point source pollution, this paper provides a scientific basis for estimating pollution loads of urban non-point source pollution and evaluating the performance of LID projects. It makes suggestions for the popularization and application of LID and sponge city design in China.

PDF全文下载地址:

https://www.hjkx.ac.cn/hjkx/ch/reader/create_pdf.aspx?file_no=20180915&flag=1&journal_id=hjkx&year_id=2018

相关话题/北京 城市 污染 中国科学院 生态