关键词: 玻尔兹曼常数/
量子电压/
噪声温度计/
约瑟夫森结
English Abstract
Development of quantum voltage noise source chip for precision measurement of Boltzmann constant
Wang Lan-Ruo1,Zhong Yuan2,3,
Li Jin-Jin2,3,
Qu Ji-Feng2,
Zhong Qing2,3,
Cao Wen-Hui2,3,
Wang Xue-Shen2,3,
Zhou Zhi-Qiang2,
Fu Kai2,
Shi Yong2
1.Department of Electricial Engineering, Tsinghua University, Beijing 100089, China;
2.National Institute of Metrology, Beijing 100029, China;
3.Key Laboratory of the Electrical Quantum Standard of AQSIQ, Beijing 100029, China
Fund Project:Project supported by National Key R&D Program of China (Grant No. 2016YFF0200402) and the National Natural Science Foundation of China (Grant Nos. 61771441, 61701470).Received Date:13 December 2017
Accepted Date:19 February 2018
Published Online:20 May 2019
Abstract:The Johnson noise thermometer is used to precisely measure Boltzmann constant by comparing the thermal noise caused by charge movement and the quantized voltage reference noise synthesized by the quantum voltage noise source (QVNS). The QVNS signal is synthesized based on quantized voltage pulses produced by two channels of superconducting Josephson junction arrays, which are designed for cross-correlation electronics. The Nb/NbxSi1-x/Nb Josephson junction is used as a core device of QVNS chip in this work for its non-hysteretic current-voltage (I-V) characteristics and conveniently adjustable barrier parameters.In this paper, we present the design consideration, fabrication process, and measurement results of the QVNS chip. The QVNS chip contains two Josephson junction arrays, each consists of four 6 μm×12 μm junctions and is embedded in a 50 Ω coplanar waveguide transmission line. The random noise in signals from the two driven channels is eliminated by cross-correlation, and then an accurate quantum noise is obtained. Test chips with different areas of Josephson junctions are also designed on the same mask, aiming at estimating the variation range of Ic. The typical fabrication process for voltage standard chips in our laboratory is used for preparing the QVNS chip.The sample is measured at 4.2 K. The DC I-V curve shows that the critical current Ic is 6.1 mA. The I-V characteristics of the junctions under 5 GHz microwave radiation are measured. For a series array of four junctions, a 41.44 μV one-stage Shapiro step is observed. Calculation shows that the error between the measurement and theoretical value of 41.36 μV is about 1.9‰, which means that the QVNS chip performs well under microwave radiation and can be used for synthesizing the AC quantum voltage reference noise.A single-frequency 100 kHz sinusoidal waveform is synthesized by the QVNS chip under pulse driven signal. A spectrum of the synthesized sinusoidal waveform shows a single peak, which means that the digital pulse signal is perfectly filtered by Josephson junction arrays and the synthesized signals possess quantum accuracy. The results indicate that our chip has good dynamic response and works well in synthesizing a single-frequency AC quantum voltage signal. This work can provide core devices for the noise thermometry system and support the precise measurement of Boltzmann constant as well as redefinition of Kelvin in future. As a next step, the design and package will be further improved, and the probe module will be optimized to reduce the measurement uncertainty.
Keywords: Boltzmann constant/
quantum voltage/
quantum noise thermometry/
Josephson junction
