关键词: 惯性约束聚变/
光谱色散匀滑/
钕玻璃激光放大器/
增益特性
English Abstract
Performance of smoothing by spectral dispersion with consideration of the gain characteristic of Nd:glass amplifier
Jiang Xiu-Juan1,Tang Yi-Fan2,
Wang Li3,
Li Jing-Hui3,
Wang Bo4,
Xiang Ying2
1.School of Electro-mechanical Engineering, Guangdong University of Technology, Guangzhou 510006, China;
2.School of Information Engineering, Guangdong University of Technology, Guangzhou 510006, China;
3.Joint Laboratory for High Power laser Physics, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai 201800, China;
4.School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou 510006, China
Fund Project:Project supported by the National Natural Science Foundation of China (Grant Nos. 11204043, 11374067) and the Open Fund of Key Laboratory for High Power Laser Physics of Chinese Academy of Sciences (Grant No. SG-001103).Received Date:16 February 2017
Accepted Date:19 March 2017
Published Online:05 June 2017
Abstract:A key issue in developing a high-power laser driver, which can be used for inertial confinement fusion and laser produced plasma experiments, is to obtain uniform irradiation on the target surface, thus a number of spatial or temporal techniques have been proposed for laser beam smoothing. A scheme combining a lens array with the technique of smoothing by spectral dispersion (SSD) is being explored in the SG-II Laser Facility located in Shanghai Institute of Optics and Fine Mechanics. As the laser system involves a variety of optical elements, their influences have to be considered in the implementation of such a scheme. The Nd:glass amplifier is one of the most important parts of the system, and the phase-modulated laser beam will propagate through it along the long light path when SSD is employed. In this paper, the performance of uniform irradiation of the target pattern is studied based on two-dimensional simulations when the gain characteristic of the amplifier is taken into account. The major factors, such as the small signal gain profile of the amplifier, the amplification factor, the bandwidth of the phase-modulated laser beam and the difference between the central wavelength of the laser and the central wavelength of the amplifier gain curve, are analyzed in detail.The numerical results show that when the central wavelength of the incident beam is different from the central wavelength of the amplifier gain curve, intensity distribution of the target pattern will be affected to a degree depending on the amplification factor; while these two wavelengths are very close to or identical with each other, variation in the intensity distribution is trivial. The symmetry of the phase-modulated laser spectrum will be destroyed due to the gain characteristic of the amplifier, especially when the bandwidth is relatively wide. However, the slight asymmetry does not result in significant influence on the spatial power spectrum nor uniformity of the target pattern, even in the case where the central wavelength of the incident beam is different from that of the amplifier gain curve. The reasons would be 1) the gain curve of the amplifier is actually quite flat within the laser bandwidth, and 2) with the technique of SSD, all spectral components contribute to the target intensity distribution within an average time. The analysis indicates that the performance of uniform irradiation of the target pattern depends mainly on the bandwidth of the phase-modulated laser beam. A wider bandwidth can always generate better irradiation when it is within a certain range, say no more than 0.3 nm, but beyond this range, the nonuniformity tends to remain at a level about 0.250.3. Multistage Nd:glass amplifiers will be employed in the practical laser driver, and the case investigated in this paper involves only one stage for simplicity. The conclusion obtained in this paper is important for implementing the technique of SSD in the laser system.
Keywords: inertial confinement fusion/
smoothing by spectral dispersion/
Nd:glass laser amplifier/
gain characteristic
