周永胜,,
张雷,
姚文明
中国地震局地质研究所, 地震动力学国家重点实验室, 北京 100029
基金项目: 国家重点研发计划（2018YFC1503404）和地震行业科研专项（201508018）资助
详细信息
作者简介: 焦裕, 男, 1991年生, 构造地质专业硕士研究生.E-mail:87242806@qq.com
通讯作者: 周永胜, 男, 博士, 研究员, 主要从事高温高压岩石力学与流变学研究.E-mail:zhouysh@ies.ac.cn
中图分类号: P313;P541收稿日期:2017-05-27
修回日期:2018-11-08
上线日期:2019-01-05
Experimental study on the effect of fluid to friction sliding of limestone fault gouge
JIAO Yu,ZHOU YongSheng,,
ZHANG Lei,
YAO WenMing
State Key Laboratory of Earthquake Dynamics, Institute of Geology, China EarthquakeAdministration, Beijing 100029, China
More Information
Corresponding author: ZHOU YongSheng,E-mail:zhouysh@ies.ac.cn
MSC: P313;P541--> Received Date: 27 May 2017
Revised Date: 08 November 2018
Available Online: 05 January 2019
摘要
摘要:在气体介质三轴高温岩石力学实验仪器上，采用意大利Scaglia Bianca石灰岩，在温度50~300℃、围压150 MPa，含50 MPa孔隙压、无孔隙压含饱和水和完全干燥三种条件下，开展摩擦滑动实验.实验力学数据和显微结构表明，完全干燥样品在120℃时出现慢滑移，实验样品中没有出现溶解与沉淀.无孔隙压含饱和水条件下，100℃、120℃、150℃条件下出现典型的慢滑移，实验样品中含有微弱的溶解与沉淀；300℃条件下出现黏滑，实验样品中出现沉淀.在含50 MPa孔隙压条件下，50℃时的实验表现为典型的稳滑，实验样品中以溶解为主；在100~150℃时，出现慢滑移，实验样品中以溶解为主，沉淀为辅；在200~300℃时，出现典型黏滑，实验样品中以沉淀为主.实验结果表明，石灰岩断层泥摩擦滑动稳定性随温度变化，受流体中碳酸钙的溶解和沉淀作用控制，因此，流体中矿物质的饱和度这一化学性质对断层带的摩擦强度和摩擦滑动稳定性具有显著影响.
关键词: 石灰岩/
摩擦滑动/
稳滑/
慢滑移/
黏滑/
溶解/
沉淀
Abstract:We performed friction experiments using Scaglia Bianca limestone gouge through a gas medium tri-axial apparatus. The experimental conditions are temperatures from 50℃ to 300℃ with confining pressure of 150 MPa, and different pore pressure. A series of experiments were conducted with pore pressure of 50 MPa, no pore pressure but saturated with water, and completely dry condition. Mechanical data and microstructures analysis show that slow slip occurs at 120℃ with completely dry condition, without dissolution and precipitation in deformed gouge sample. Under the condition of no pore pressure but saturated with water, typical slow slip occurs, accompanied with little dissolution and precipitation in fault gouge under temperatures of 100℃, 120℃, 150℃, whereas, stick-slip occurs with a lot of dissolution and precipitation in gouge at 300℃. It is stable sliding with main mechanism of dissolution in gouge at temperatures of 50℃ and pore pressure of 50 MPa. It shows slow slip with main mechanism of dissolution and supplemented by precipitation in deformed gouge at temperatures of 100~150℃, stick-slip occurred at 200~300℃ with main mechanism of precipitation. The results indicated that the transition from steady-state slip to slow slip and to stick-slip with temperatures increasing, which was controlled by dissolution and precipitation of limestone gouge, that may help to understand the chemical effect of fluid to fault sliding.
Key words:Limestone/
Frictional slip/
Stable sliding/
Slow slip/
Stick slip/
Dissolution/
Precipitation
PDF全文下载地址:
http://www.geophy.cn/data/article/export-pdf?id=dqwlxb_14830
